Here I have created a custom circuit board. It is made from military grade PCB material with 2oz
copper clad (very thick).  I used an 8 amp full bridge rectifier, and moved the caps to the top. The
heat sync is designed for computer chips, and is affixed with a special heat conductive glue.  This
will dissipate a lot of heat (modern computer technology is great, isn't it?).

The bottom is much cleaner also... fewer wires. The traces are not real pretty because this heavy
clad is hard to etch. It is in the tank so long that the etch solution begins to attack the mask along
the edges. But Wow... it's like laying 20 ga. Wire across the board !!!  It will handle a huge current
load.
Next Page ->